Soundproof Mobile Wall Conference Training Center Acoustic Room
How to operate the acoustic room dividers?
1. A typical acoustic room divider consists of bulb seal panel (BSP).
basic panel(BP), an optional pass door(PD),additional basic
panels(BP), and last a closure panel(LCP). Stand in the center of
the panel face. Using both hands, grasp it by the edges as high as
possible and gently pull it toward you. Carefully maneuver the
panel out of the storage area. Move the acoustic room divider panel
down the track to the required position. Once in place, push it
firmly against the adjacent wall or panel to insure a tight joint.
You may place your foot against the bottom of the panel to hold it
in place while you extend the acoustical seals.
2. Seal Operation for Retractable Seals: Once the acoustic room
divider panel is in position,insert the operating crank handle over
the exposed shaft in the panel's vertical edge. While keeping the acoustic room divider panel plumb, turn the
operating key clockwise approximately 180degrees. This will extend the seals. Remove the operating handle
and repeat with remaining basic panels.
3.Optional Pass Door Panel-Setup
U-Shaped (single style): The pass door has two seals. One located
in the same place as the basic panels (A) and the other located
inside the door jamb (B). Set the (A) seal first by inserting the
operating key over the seal mechanism as shown in Exp e, A. Turn the operating key until the floor seal is extended.Next
open the door and turn the seal mechanism located in the jamb (B)
in the same way as you did for seal (A).
4.Optional Pass Door Panel-Setup (continued)
L-Shaped Pass Door(double door). Batwing doors consist of two L-shaped panels. A L-panel has a
single seal. Push the lead end of the first L-panel into place, but
do not set the seal. Push the second panel (trail L-panel) into
place and extend the seal (A) in the same manner as a basic panel.
Turn the operating key until the floor seal is extended. Next, open
the door on the lead L-panel and extend the seal located in the
pass door jamb (B).
5.Setting the Final Closure Seals.
Final closure will bel Lever Closure Panel .Move the last panel
into place. If you you will need to extend two seals on the last
panel in the opening. The first seal is located in the trail edge
of the panel. Insert the operating key over the exposed shaft in
the vertical edge and turn key 180 degrees clockwise to set the top
and bottom seal. (The shaft may be hidden from view by the
expanding post). To extend the second seal, insert the operating
key over the shaft located on the face of the panel. Turn the key
clockwise until you feel resistance against the wall. This action
extends the closure and completes the acoustical seal. Note: Make
certain you apply sufficient pressure to compress the vinyl seal
against the wall.
|Series||Model 65||Model 85||Model 100|
|Panel suspension||Top hung only||Top hung only||Top hung only|
|Panel thickness||65 mm||85 mm||100 mm|
|Max height||4000 mm||6000 mm||8000 mm|
|Panel width||600-1230 mm||600-1230 mm||600-1230 mm|
|Based board thickness||9 mm||9 mm||9 mm|
|Pass doors selection||Single Door or Double Door|
|Sound insulation||20 – 32 db||28 – 36 db||32 – 50 db|
|Finish Material||Plywood / MDF /Laminate / Melamine / Gypsum|
|Board / Fabric / Insulation / Fireproof /Wall Paper /Vinyl
Acoustic room divider is usually used where indoor space needs to
be fully utilized. Hotels, convention centers, educational
institutions, offices, training areas can all benefit from the
flexibility of acoustic room dividers system.